58
ATAG
Fig. 3:
Then take hold of the
second inner pane
C
securely with both hands and push it out upwards.
Once the inner panes have been removed, clean
the door and the panes.
Clean the glass panes with warm water only. Do
not use rough cloths, scouring pads, steel wool,
acids or abrasive products, so that the surfaces of
the glass panes and the door are not damaged.
After cleaning, re-insert the inner panes.
To correctly mount the inner pane
C
(with
side decors along the frame), the surface
marked with stripes has to face the oven
cavity in a way that, when touching the
surface on sight, the light roughness of the
silk-screen printing is perceptible.
To correctly mount the inner pane
B
(with
side decors on two lateral sides), the surface
marked with stripes has to face the oven
door in a way that, when touching the
surface on sight, the light roughness of the
silk-screen printing is not perceptible.
After reinserting the inner panes:
Fig. 4:
insert the perforated plate
A
back in its
original position and check that everything is
securely fastened and firm.
Appliances in stainless steel or aluminium
We recommend you only clean the oven door with
a wet sponge and then dry it afterwards with a soft
cloth. Never use scourers, acids or harsh abrasives,
as these can damage the surface. Clean the panel
with the same care.
DO NOT
clean the oven door while the glass
panels are warm. If this precaution is not
observed the glass panel may shatter.
If the door glass panel becomes chipped or has
deep scratches, the glass will be weakened and
must be replaced to prevent the possibility of the
panel shattering. You can find your local service
address in the Guarantee Card Contact or via
www.hps.nl.
Fig. 4
A
Fig. 3
C
