EN 13
Installation
Drilling the support surface and fitting the Hood
• The hood can be fitted directly on the lower surface of the wall units
using the snap-on Side Supports.
• Make an opening on the lower surface of the wall unit, as indicated.
• Screw the closing profile
20
onto the rear part of the hood, using
the screws
12e
(2.9 x 12.7) provided.
• Open the glass panel.
• Remove the metal grease filters one by one by turning the hooks
provided.
• Close the glass again.
• Insert the hood until the snap-on side supports click into place.
• Open the glass panel.
• Lock in position by tightening the screws
Vf
from underneath the
hood.
437
255
437
255
Vf
12a
INSTALLATION
Summary of Contents for WV6311NM
Page 60: ...528609 VER 2 10 09 2015 ...