wwwAtairCanopies.com
Troll DW Canopy User Manual
Page 17 Atair Canopies
Section 7.2: Packing with a Slider
DO NOT USE A TAIL GATE WHEN PACKING WITH A SLIDER. Ensure proper line continuity
and be certain that the control lines go from the outside of the canopy through the
slider grommet of the rear riser on its corresponding side. Then take the control line
through the guide ring on the corresponding riser. Refer to section 8 to ensure proper
control line routing and toggle assembly.
Figure
4a
Figure
4b
Follow the previous packing instructions up through figure 2. For slider placement,
ensure proper line continuity, keeping the left and right separation with the front slider
grommets closest to the canopy. The slider tape should be facing upward. Pull the
slider so that the front grommets rest against the bottom of the stabilizers at the B line
slider stops on both the left and right hand side. Gently lift the tape between the two
rear grommets of the slider and pull up until the grommets are resting against the
bottom of the stabilizers at the C line slider stops on both the left and right side.
The slider tape and fabric between the front and rear grommets should be placed
between the B and C fold of the canopy. Be certain that this is done to the left and
right side. This is basically quartering the slider. We don’t stow our sliders. Go to section
7.3 to continue with your pack job.
