Refer to the appropriate figure while connecting the cables as follows:
1
Connect the line cord to the AC power-in socket (A).
N o t e
On the 6386E/33 WGS floor model, this socket is located at the base of
the system module in the rear
On the 6386E WGS floor model, this socket is located on the back of
the power supply.
2
Connect one end of the video monitor power cord to the video monitor
and the other end to the monitor power outlet
(B).
N o t e
On the 6386E/33 WGS floor model, this socket is located at the base of
the system module in the rear
On the 6386E WGS floor model, this socket is located on the back of
the power supply.
3
Connect the video monitor signal cable to the VDC board
connector (C).
4
Connect the keyboard to the keyboard interface port (D).
5
Connect the mouse (if any) to the mouse port
(E).
6
Connect a parallel printer (if any) to the parallel port (F).
7
Connect a remote access modem (if any) to serial port 1 (G).
2-48 Hardware Installation and Maintenance
Summary of Contents for 6386 WGS
