6
Type 1 for create a partition and press [Enter].
The system prompts you to indicate the type of partition to be created.
7
Type 1 for a
UNIX
partition
and press [Enter].
The UNIX System partition must
disk.
Indicate the percentage
want this partition to use (or
cylinders):
8
Type 100 and press [Enter].
Do you want this to become the
use at least 25% of the hard
(25-100) of the hard disk you
enter “c” to specify in
Active partition? If so, it
will be activated each time you reset your computer or when
you turn it on again. Please type “y” or “n”.
9
Type y and press [Enter].
Cylinders
Partition Status Type Start End Length %
1
Active UNIX O
<end> <max> 100
SELECT ONE OF THE FOLLOWING:
1.
Create a Partition
2.
Change Active (Boot
3.
Delete a Partition
From) Partition
4.
Exit (Update Disk Configuration and Exit)
5.
Cancel. (Exit Without Updating Disk Configuration)
Enter Selection:
3-6 Software Installation
Summary of Contents for 6386 WGS
