Select Ring
✔
To select a personalized
ring
1
Press [
Select Ring
] (while on-hook)
●
Green light goes on
Press [
#
]
2
●
Green light winks; current ring pattern plays and
repeats every 4 seconds
3
Adjust ringer volume with volume control switch on
left side of voice terminal, if desired
4
Repeat Step 2 to cycle through all 8 ring patterns
5
Press [
Select Ring
] again when you hear the desired
ring pattern
●
Your new ring is set; green light goes off
Note:
If you receive a call go off-hook, or lose
power during selection, process is interrupted and
you must start again. If you lose power after you
have selected your personalized ring, you will have
to select your ring pattern again.
Self-Test
✔
To test the lights and
ringer of your voice
terminal
1
Press [
Select Ring
] (while off-hook)
●
Green light goes on steadily
2
Press and hold [
Drop
]
The following occurs in sequence:
●
Ringer sounds; Message and Select Ring lights
and two columns of lights directly above dial pad
go on steadily for one second and then go off.
●
First column of lights to right of dial pad goes on
steadily for one second and then goes off
●
Second column of lights to far right of dial pad
goes on steadily and then goes off
3
Release [
Drop
] to end test
●
Ringer and lights return to pretest state
Note:
If ringer or lights do not respond during
test, notify your System Manager.
18
