Testing Outgoing and
Test dial repeating he lines, wink start, immediate start,
Two-way Dial
and delay start tie lines when you are sure that someone is
Repeating Tie Lines
available to receive your call at the far end. Follow these
steps:
1
2
3
4
5
At any voice terminal that has a tie line appearance,
press the first tie line button.
The red light jumps to the tie line button just pressed.
Lift the handset.
The green light goes on next to the red light.
Dial the tie line number of the station where someone
is waiting for your call.
You hear ringing.
Veify two-way communication and then hang up.
Repeat this procedure for each tie line administered.
Testing Incoming and
Have someone at the far end system, where the tie lines
Two-way Automatic
are connected, place a call to you at the MERLIN II
Ringdown Tie Lines
system automatic ringdown console. Follow these steps:
1
2
3
4
At a preset time, the person at the far end places a call
to your system.
You hear ringing at the console connected to the tie line and the
green light flashes next to the button that has the tie line
appearance.
Lift the handset,
The red light goes on next to the tie line button and the green light
becomes steady.
Verify two-way communication and then hang up.
Repeat this procedure for each tie line administered.
Testing the System 2-105
Summary of Contents for administration and
