AT&T Digital Magic Messenger
Operational Notes
1 .
2 .
3 .
4 .
If the telephone line has "call-waiting," this service must be
terminated by your phone company in order for the Magic
Messenger to operate properly.
The RECORD, PLAY and MODE lights flash when you first apply
power or following a power interruption of over 2 hours in
duration (announcements erased).
The Magic Messenger will answer an incoming call before you
hear it ring. The PLAY light will come on to indicate the unit has
answered a call (after the announcement has played, the light will
go out). After playing the message, the Magic Messenger will ring
through whenever the caller presses a touch tone button on his
phone. If the caller is not using a touch tone phone, the Magic
Messenger will ring through automatically after 15 seconds.
During this waiting period, the caller will hear a beep tone every
few seconds. The typical cycle will be: 15 second delay with
beeps followed by 2 sec. tone, 4 sec. delay and then ring the local
telephone. A disconnect signal or DTMF tone will interrupt the
process and cause the unit to either disconnect or ring
immediately to the local extension.
If a caller does not hang up within 2-3 seconds after the
announcement has finished playing, but hangs up before the 15
second waiting period is complete, the unit may produce a short
ring at your attendant console or telephone extension.
Remote Operation
Remote operation lets you:
●
●
●
●
Select the day or night announcement from any touch tone phone.
Listen to the night announcement.
Record a new night announcement.
Change your remote access password.
14
AT&T Digital Magic Messenger
To Use the Remote Operation Feature:
1 .
2 .
3 .
Call the Magic Messenger from a touch tone telephone. During
the announcement press [#] followed by your two-digit password
(the factory preset password is [#] [#]). (Note: if there is more
than 1.5 seconds between each key press, the unit will ring the
telephone connected to the Magic Messenger and you will have
to hang up and start over).
After dialing the password, you will hear a short beep tone every
second. This indicates that the Magic Messenger is ready for
remote instructions.
Press [1] to select the DAY announcement.
Press [2] to select the NIGHT announcement.
Press [5] to listen to the current NIGHT announcement.
Press [6] to record another NIGHT announcement. Begin
recording after you hear the beep tone. Press [#] when finished*.
Press [7] to record DAY announcement. Begin recording after
you hear the beep tone. Press [#] when finished*.
* Note: The Magic Messenger has 52 seconds of digital storage
available to record both day and night announcements. If one
announcement is recorded and the second announcement
exceeds the total time available, it will overwrite a portion of the
first announcement. Therefore, you should time each
announcement to make sure that you do not exceed the time
limit.
Press [8] to listen to the current DAY announcement.
Press [0] to change the password, followed by two digits for the
new password. (If you forget the password, you must turn the unit
off to reset the Magic Messenger to the original factory preset
password. You will also have to rerecord your announcements.)
Press [*] to place the unit in BYPASS mode. If the unit is in
bypass mode it will automatically switch to answer mode upon
detection of 15 rings, play the current day announcement and
resume normal operation.
After you make a selection, you will hear a confirmation tone followed
by the beep tone evey second (as in step 2 above). At this point you
can hang up the phone or make another selection.
15
Summary of Contents for Digital Magic Messenger System
Page 16: ...AT T...
