Installation and setup
Connect the base and install batteries as shown below. After installation, place the
handset in the base and allow the battery to charge for 12 hours before use. You can
keep the battery charged by returning the handset to the base after each use.
Connect charger as shown, then place handsets in base
and charger to charge for 12 hours before first use.
Press coin into slot on
base of handset to
release latch, then
remove battery cover.
Insert supplied
batteries.
Insert top tab first.
Press down to
click in place.
Plug power cord
transformer into
electrical outlet.
Plug long telephone
line cord into
telephone jack.
Route cords through
slot in base.
Caution:
Use only the supplied NiMH battery (80-
5461-00-00) or AT&T model 2AA NiMH replace-
ment battery (SKU 26820).
Do not use alkaline
batteries
.
ATT-5900BQSG-d2.qxd 1/23/2004 5:21 PM Page 3
