Resetting the
To reset the call handling traffic statistics to O, perform the
Counters
following steps:
1
Dial the MERLIN II Attendant extension from a
Touch-Tone phone, preferably a single-line set.
N O T E :
If you are programming from a multiline
Touch-Tone phone connected to a
MERLIN II system control unit, you must
enter an additional pound (#) sign each time a
pound (#) sign appears in a programming
command.
2
Wait for an answer.
3
Dial * followed immediately by the authorized caller
code and #.
4
Dial *29101.
5
Exit authorized caller mode by dialing *#.
6
To disconnect, dial #.
Printing Call
To print the current settings of call processing options,
Processing Reports
perform the following steps:
1
Dial the MERLIN
II Attendant extension from a
Touch-Tone phone, preferably a single-line set.
2
Wait for an answer.
3
Dial *
followed immediately by the authorized
caller
code
and #.
4
Dial *29 followed by the appropriate selection:
01
=
Day Answer Delay
02
=
Night Answer Delay
03
=
Dialing Delay
3-8 Troubleshooting
Summary of Contents for MERLIN II Attendant
Page 1: ...AT T MERLIN II COMMUNICATIONS SYSTEM MERLIN II Attendant Installer s Guide...
Page 21: ...FIGURE 1 4 Connecting the MERLIN II Attendant Connecting the MERLIN II Attendant 1 17...
Page 33: ...FIGURE 2 2 Supervised Transfer process 2 12 Programming Features...
Page 35: ...FIGURE 2 3 Immediate and Backup Call Handling 2 14 Programming Features...
