Page 1 of 4
Quick Reference Guide For
Merlin II R3 – System Administration
System Administration –
Place the administration overlay on the Merlin II display
console. Enter
System Administration
from station 10 by pulling the switch on the left-
hand side of the Merlin II display console down to ‘P’ and pressing the
Conference
button 2 times. The following procedures are performed while in
System
Administration
mode.
System Administration programming procedures
Attendant Positions
– Press
System
,
Attendnts
,
Position
. Press the DSS button of a
station to assign it as an attendant (green light on). Only every fourth Merlin station jack
may be assigned as an attendant (10, 14, 18, etc.). A max of 8 attendants can be assigned.
Call Restriction
– Press
Stations
,
Restrct
. Press the DSS button of the station to
restrict. Press
Enter
. Press a key for the restriction desired;
NoRestr
= unrestricted,
Local
= toll restricted,
Intercom
= outward restriction.
Group Call Distribution
– Press
Stations
,
More
,
GrpCall
. Dial group number
(870-875). Press
Enter
. Press the DSS buttons of the stations to assign (green light on).
To associate lines or pools with this group press the line or pool button to assign (green
light on).
Group Page
– Press
Stations
,
More
,
PageZn
. Dial group number (881-886). Press
Enter
. Press the DSS buttons of the stations to assign (green light on).
Loudspeaker Page
– Press
More
,
Options
,
XtrnPg
. Press the line button to be assigned
as the
Loudspeaker Page
jack (green light on). A line must be unassigned from pools or
any line appearances before it can be assigned to
Loudspeaker Page
.
Music-On-Hold
– Press
More
,
Options
,
Music
. Press the line button to be assigned as
the
Music-On-Hold
jack (green light on). A line must be unassigned from pools or any
line appearances before it can be assigned to
Music-On-Hold
.
Recall Timer Interval
– Press
More
,
Options
,
More
,
More
,
Recall
. Dial number to
specify
Recall Timer Interval
; 0 = 350 msec, 1 = 450 msec, 2 = 650 msec, 3 = 1 sec.
Press
Enter
.
System Renumbering
– Press
System
,
More
,
Renumbr
. Wait for system to restart.
This procedure is performed when modules are changed in the control unit.
System Size
– Press
System
,
Size
. Press
Small
(8 lines or less
and
20 phones or less), or
press
Large
(more than 8 lines
or
more than 20 phones).
