MERLIN LEGEND System Programming
Setting Up the RMD
Follow these procedures to setup the RMD:
1. (Key mode only) Remove all lines from the RMD. To do this, enter
programming mode, Select
“Extensions”,
then
“Line Trunks”
and follow the prompts. For Hybrid/PBX mode, skip this step.
2. Restrict the RMD from making outside calls. To do this, enter
programming mode, select
"Extensions"
then
“Restriction”
and follow the prompts. For Restriction Type, choose
“Outward
Restrict”.
For more details on these procedures, refer to the MERLIN LEGEND System
Programming Guide.
Optional System Features
The following features are available for your convenience, but are not required
for the operation of the MERLIN MAIL—ML system.
Message-Waiting Receiver
It is useful to designate an extension as a message-waiting receiver when
calls are transferred to a Calling Group. The message-indicator lights on the
designated extension whenever a caller leaves a message for the Calling
Group.
■
Use MERLIN LEGEND Form 6e to identify the Message-Waiting
Receiver extension number.
■
Only one telephone can be designated as the Message-Waiting
Receiver.
■
More than one Calling Group can have the same
Message-Waiting Receiver if the Message-Waiting
display set.
Receiver is a
Optional System Features
4-33
Summary of Contents for MERLIN MAIL
Page 13: ...Contents GL Glossary GL 1 IN I n d e x IN 1 vi...
Page 64: ...MERLIN MAIL ML System Programming Figure 3 1 MERLIN MAIL ML System Programming Menus 3 2...
Page 151: ...MERLIN LEGEND System Programming Figure 4 3 Immediate Call Handling Call Handling Methods 4 15...
Page 161: ...MERLIN LEGEND System Programming Figure 4 4 Delayed Call Handling Call Handling Methods 4 25...
