Installation
Mounting the MERLIN MAIL—ML Unit
Refer to Figures 2-3 and 2-4 as you follow the instructions for mounting the
MERLIN MAIL—ML unit below:
1. Remove the wall mount and cable manager bracket from the shipment
package.
2. Position this bracket so that the slot is upward and use the bracket as a
template to mark the four points on the plywood surface or wall studs
where the wall-mounting screws will be inserted.
WARNING:
Be sure to install the wall-mounting screws in wall studs or in a
piece of plywood to ensure permanent mounting and to prevent
wall damage.
3. Secure the wall mount and cable manager bracket as shown in
For mounting on plywood, use the four #8 X 3/4-inch pan-head sheet
metal screws provided (or their equivalent). For mounting to wall studs
through drywall, use four #8 x 1 1/4-inch (or longer) pan-head sheet
metal screws.
4. From the rear panel of the MERLIN MAIL—ML cabinet, remove the #6-32
hex-head screw from the mounting hole on the lower right. (See Figure
2-4 for position of screw.)
Installing the MERLIN MAIL—ML Unit
2-7
Summary of Contents for MERLIN MAIL
Page 13: ...Contents GL Glossary GL 1 IN I n d e x IN 1 vi...
Page 64: ...MERLIN MAIL ML System Programming Figure 3 1 MERLIN MAIL ML System Programming Menus 3 2...
Page 151: ...MERLIN LEGEND System Programming Figure 4 3 Immediate Call Handling Call Handling Methods 4 15...
Page 161: ...MERLIN LEGEND System Programming Figure 4 4 Delayed Call Handling Call Handling Methods 4 25...
