MERLIN MAIL—ML System Programming
Identifying Fax Extensions
Program the fax or fax calling group extension where the Automated
Attendant Service will transfer fax calls.
■
MERLIN MAIL—ML Form A: System Parameters identifies the
planned fax extension.
■
If the MERLIN MAIL—ML system has been set up for monolingual
operation, the Touch-Tone Gate is set “On” automatically when
you program the MERLIN MAIL—ML system to receive fax
messages. This enables fax calls to be immediately detected and
sent to the fax extension or extension of the fax calling group.
To program the fax extension, follow the instructions below:
1. Log in to the MERLIN MAIL—ML system as the system administrator.
The system administrator’s name plays; then the Voice Mail Activity Menu
plays.
2. [9] to program the system.
The System Administration Menu plays.
3. [1] for System Parameters,
The System Parameters Menu plays.
4. [4] to change the fax extension.
The current fax extension plays, followed by a prompt to enter the fax
extension number.
5. Enter the fax extension followed by [#]
The fax extension number plays, along with the message “The Touch-Tone
Gate is on” if the MERLIN MAIL—ML system is set up for monolingual
operation. The system then plays the System Parameters Menu.
Programming MERLIN MAIL—ML System Parameters
3-15
Summary of Contents for MERLIN MAIL
Page 13: ...Contents GL Glossary GL 1 IN I n d e x IN 1 vi...
Page 64: ...MERLIN MAIL ML System Programming Figure 3 1 MERLIN MAIL ML System Programming Menus 3 2...
Page 151: ...MERLIN LEGEND System Programming Figure 4 3 Immediate Call Handling Call Handling Methods 4 15...
Page 161: ...MERLIN LEGEND System Programming Figure 4 4 Delayed Call Handling Call Handling Methods 4 25...
