25
Getting started
Headset base installation
Option 2: Connect the headset to a telephone wall jack
In order to make calls using this installation option, you need a
telephone plugged into the same telephone line or a dial pad
(TL7601 purchased separately). Make sure the headset base
mode is set to
NO
LIFTER MODE
.
Plug one end of the
telephone line cord
into the
TEL WALL JACK
(red
dot) at the back of the
headset base.
•
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
Telephone
line cord
Plug the other end of
the telephone line cord
into a telephone jack.
•
Plug the headset
base power adapter
into an electrical
outlet not controlled
by a wall switch.
•
Plug the small end of
the headset base power
adapter into the
POWER
jack (green dot) at the
back of the headset base.
•
NOTE:
For more information about the accessory dial pad (model TL7601),
visit our website at
www.telephones.att.com
.
