28
Getting started
Adding and registering a headset to the
headset base
To register a headset to the headset base
Make sure the battery is properly installed in
the headset (see page 11). The
ON/OFF
light
flashes twice every five seconds to indicate the
headset is not registered.
Place the headset in the headset base and
allow it to charge for at least five minutes
before registration.
Remove the headset from the headset base.
Press and hold the
PAIR
button until the
MUTE
light on the headset base turns on
(about four seconds) and release the button.
Return the headset to the headset base
for registration.
It may take about 30 seconds to complete the
registration. The
MUTE
light on the headset
base turns off. The headset
ON/OFF
light
turns blue on the first headset registered. The
headset
ON/OFF
light turns orange on the
second headset registered.
To verify the registration was successful, press
the headset
ON/
OFF
button and check for a
dial tone.
If the registration fails, the
ON/OFF
light on the headset flashes
twice every five seconds. To reset the headset, remove the headset
from the headset base and try the registration process again.
1.
2.
3.
4.
5.
