40
Operation
Headset operation
Ending a call on the headset
When the headset base is connected to a corded handset of
your telephone with the handset lifter installed (option 1):
Press
ON
/OFF
on the headset or place the headset in the
headset base to end a call. The switch hook presser pushes
down the switch hook and ends the call.
When the headset base is connected to a telephone wall jack,
or connected to a corded or cordless phone (option 2 or 3):
Press
ON
/OFF
on the headset or place the headset in the
headset base.
Auto off
A call ends automatically when you put the headset in the
headset base.
Temporary ring tone silencing
Press
MUTE/
FLASH
to temporarily silence the ring tone in
the headset earpiece. This silences the ring tone without
disconnecting the call. The next incoming call rings at the
preset volume.
NOTE:
If you have more than one headset registered to the headset base, both
headsets receive the ring tone when there is an incoming call. Pressing
MUTE/
FLASH
on one headset only silences the ring tone of that particular headset.
•
•
