Getting started
To register a headset to an AT&T DECT cordless telephone base
You must deregister the headset from its
headset base (see page 15).
Make sure the battery is properly installed in
the headset (see page 9). The light on the
headset flashes slowly and alternately
in blue and red to indicate the headset is
not registered.
Place the headset in the headset base and
allow it to charge for at least one hour
before beginning registration.
Remove the headset from the headset base
and then place it back to its base.
On the telephone base of the cordless phone,
press and hold
/
HANDSET LOCATOR
until
the red
IN USE
light comes on (about four
seconds) and then release the button.
The headset is registered to the telephone
base automatically.
It takes about 60 seconds to complete the
registration. The
light turns blue when it is
registered.
To verify the registration, press the
button
on the headset and check for a dial tone. If the registration fails,
you hear the voice prompt
"Not registered"
and the
light on
the headset flashes slowly and alternately in red and blue.
To reset the headset, remove the headset from the headset base
and try the registration process again.
1.
2.
3.
4.
5.
6.
Add and register headsets
14
