Getting started
7
Headset charger installation and battery charging
After installing the battery, charge the headset by placing it in
the magnetic charging mount, as shown below. The
light turns
on when the headset is charging.
IMPORTANT INFORMATION
Use only the supplied rechargeable battery pack or replacement
battery pack (model BT191665). To order, visit our website at
www.telephones.att.com
or call
1 (800) 222-3111
.
In
Canada, dial
1 (866) 288-4268
.
The magnet holds the top
of the headset in place.
The
light turns on.
3.
Plug the small end of the headset charger power adapter
into the power jack at the bottom of the headset charger.
Route the power cord through the power cord slot. Plug the
large end of the power adapter into an electrical outlet not
controlled by a wall switch.
1.
Insert the headset into the
magnetic charging mount.
2.
Magnetic
charging mount