Getting started
9
Register a headset to the TL7910/TL7912 headset base
Make sure the battery is properly installed in the
headset (see page 6). The
light flashes slowly
in red and blue to indicate the headset is not
registered.
Place the headset in the headset charger and
allow it to charge for at least one hour before
beginning registration.
Remove the headset from the headset charger.
Press and hold the
PAIR
button on the headset
base that is registering this headset (about four
seconds). When the
MUTE
light on that headset
base turns on, release the button.
Return the headset to the headset charger
for registration. The
light flashes quickly
in red and blue.
It takes about 60 seconds to complete the
registration process. The
The
light turns red
when the headset is registered but not fully
charged, or turns blue when it is registered
and fully charged.
If the registration fails, you hear the voice prompt
"Not
registered"
when you press the button on the headset, and the
light on the headset flashes slowly in red and blue.
To reset the headset, remove it from the headset charger and try
the registration process again.
NOTE:
You cannot register a headset if another system headset is in use.
1.
2.
3.
4.
5.
Adding and registering headsets
