45
Appendix
California Energy Commission battery charging
testing instructions
This cordless headset is set up to comply with the energy-conserving standards right
out of the box. These instructions are intended for California Energy Commission (CEC)
compliance testing only. When the CEC battery charging testing mode is activated, all
telephone functions, except battery charging, will be disabled.
If you have registered the cordless headset to the
TL7910/TL7912
headset base,
below are the testing instructions.
To activate the CEC battery charging testing mode:
Unplug the headset base power adapter from the power outlet. Make sure the
headset is plugged with charged battery before proceeding.
Press and hold
PAIR
on the headset base while powering up the base by plugging
in the adapter.
After about 20 seconds, when the
MUTE
light on the headset base starts flashing,
release
PAIR
and then press it again within two seconds.
The process takes up to one minute to complete. When the headset
successfully enters the CEC battery charging testing mode, the light flashes
slowly in red and blue.
Note:
When the headset fails to enter this mode, repeat all the steps mentioned above.
To deactivate the CEC battery charging testing mode:
Unplug the headset base power adapter from the power outlet, then plug it back in.
The headset base is powered up as normal.
Register the headset back to the headset base. See pages 8-11 for headset
registration instructions.
If you have registered the cordless headset to a compatible AT&T DECT cordless
telephone, please refer to the respective user's manual for the activation and
deactivation of CEC battery charging testing mode.
If you have registered the cordless headset to a telephone base that does not have CEC
battery charging testing mode, all telephone functions on the cordless headset, except
battery charging, will be disabled.
BC
1.
2.
3.
1.
2.