Applied Thermal Control Ltd
39 Hayhill Industrial Estate
Barrow-upon-Soar, Loughborough
LE12 8LD, United Kingdom
+44 (0) 1530 839 998
Service@thermalexchange.co.uk
Support@app-therm.com
Operating Manual; Controller Operation
Annex E-1
DOCUMENT DETAILS
Date 5/DEC/2019
Author(s) MJH
Page 4 / 9
Revision 1
Maintenance Prompt View
1. Move up the parameter list.
2. Move down the parameter list.
3. Date is editable, tap to adjust next check date. When date is
reached, text becomes red.
4. Exclamation mark is shown for overdue. Tap to confirm
check made.
5. Tick mark is shown by black text for maintenance not due.
Passcode Entry
1. Pressing the settings gear icon shows the passcode screen.
Enter 4159 to enter factory settings.
Enter 1234 to enter user settings.
2. Passcode appears in box above keyboard.
3. Select to enter passcode.
Factory Settings (1)
Screen available after successfully entering the passcode.
1. Down arrow scrolls through factory settings pages.
2. Pressing the settings icon again takes you to user settings.
User settings are a cut-back version of factory settings.
3. Return to main carousel.
4. Serial number, commissioning date, default power on, etc.
5. Temperature and pressure display units, etc.
6. Edit the text parameters of various maintenance prompts.
7. Edit temperature and pressure limits before error log.
8. Where capable, modify MODBUS settings.
Factory Settings (2)
Scroll down from ‘Factory Settings’ (1)
Further to ‘Passcode Entry’ above;
1. To access higher level settings, the user settings PIN can
be edited while access has been gained to
‘Factory Settings’
.
2. Where standby mode is enabled, this PIN appears to
prevent the user from starting process without PIN entry first.
1
2
4
5
3
1
2
3
1
2
3
4
5
6
7
8
2
1
Annex E-1 200707 XTD controller XTD043RB-K620G&F (Mini at SW v39.4)
13