Lift the towel rail with the inner sleeve assemblies in
the approximate position and align with the outer
sleeves that were previously fixed to the wall.
When all the inner sleeves are inserted correctly into
the outer sleeves of the brackets tighten the screws
on the inner sleeves and install the screw cover caps.
The small Phillips head screws (part 3) can now be
installed into the screw holes in the outer sleeves.
When the towel rail is the desired distance from the
wall, the small Phillips head screws can be tightened
to fix the rail securely
Operation
Once powered the heat will be distributed along each
of the rails. Some variation in the temperature across
the surface of the rail is also normal. When the
appliance is covered the heating pattern of the rails
may alter, and generally temperatures at the upper
part of the towel rail will rise.
The towel rail may be switched on and off at the
isolating wall switch or operated by means of a pull
cord switch.
A further means of control would be to link the towel
rail to a room thermostat and/or timer. A room
thermostat will ensure that the rail automatically
switches off in warmer weather. A timer will allow for
short periods of use.
Note
: If the towel rail is located in a bathroom the
adjustment for these controls must be located outside
the bathroom.
It is recommended that for efficient drying, no more
than two layers of towels or similar fabric should be
draped over the rail. Items should be placed evenly
over the whole surface of the rail where possible.
It is not advisable to leave very damp towels or
clothes on the towel rail when it is not in use, as this
may in time, affect the finish.
The rail, although hot to the touch is not hot enough
to scorch or burn fabrics. However, soap or
detergents that remain in articles after washing can
cause discoloration. Care should be taken to
thoroughly rinse articles before airing.
Maintenance
There are no user serviceable parts on the towel rail.
The rail is filled with a precise quantity of special
liquid and should never need draining or refilling.
Repairs requiring the opening of the liquid-tight seal
must only be made by the manufacturer’s Service
Agent. Any leakage must be reported to the
manufacturer’s Service Agent.
The element and cable are a single unit and any
maintenance, must be carried out by the
manufacturers Service Agent using the recommended
parts.
Cleaning
The finish on your towel rail can be maintained by
occasionally wiping over with a damp cloth and lightly
finishing with a soft dry cloth. This should only be
carried out when the rail is cold. Do not use abrasive
cleaning powders as this could damage the surface
finish.
Recycling
For electrical products sold within the
European Community. At the end of the
electrical products useful life it should not
be disposed of with household waste. Please recycle
where facilities exist. Check with your Local Authority
or retailer for recycling advice in your country.
Guarantee
Your appliance is guaranteed for 2 years from the
date of purchase – during this period we will repair or
exchange, at our discretion, any faulty or defective
parts providing the appliance has been used in
accordance with the operating & installation
instructions and has not been misused or mistreated
in any way.
Any unauthorised repair or attempted repair will
invalidate the guarantee. You may be asked to return
the product to our workshop for inspection to
establish whether the fault is covered under the
guarantee. The guarantee is valid in the UK and
Ireland only. This guarantee is additional to your
statutory rights. In the unlikely event of a problem
with your appliance, please contact your supplier.
Should you require after sales information or
assistance with this product please go to
Please retain your receipt as proof of purchase.
ATC Electrical & Mechanical
ATC House
Broomhill Drive
Tallaght
Dublin
D24 EF99
UK: 0203 5649164
Ireland: 01 467 8301
Web:
Email:
