LPX-1000 Scanner System
User Manual
Section 2
Copyright © 2008-2012 ATCO. All Rights Reserved.
850-004134
Page 9
Revision A.0
Figure 16
Remove Belt Clip Screw
Pull Slide From
the Y Axis
Remove (2)
Screws
Figure 15
Removing the Slide Block
Fasten the Belt Clip
Belt Clip
Mounting Point
Screw
Spacing for Screw
Figure 17
Fastening the Belt Clip
Step 3
Remove the slide block (Figure 14).
Step 4
Remove the screw that holds the belt to the clip, and remove
the old belt. (Figure 15). Place the clip on the new belt and
secure the screw.
Step 5
Fasten the belt clip on to the new belt. Be sure to fasten
the clip to the appropriate location on the belt. There is
a belt clip mounting point with the appropriate spacing
for the screw (Figure 16).
