PaloSanto Solutions
Atcom AT620P Server Setup Guide
7
MANUAL CONFIGURATION
1. Use the information from the Add SIP Extension page (Figure 4-4) to enter the
following necessary information on
“
VOIP => SIP 1
”
section of the Atcom Phone
WebUI:
Server Address:
Elastix Server’s IP Address (192.168.
1.65 in this example)
Account Name: 301 in this example
Password:
‘h7Dka3Rf9si0t’ in this example
Phone number: 301 in this example
Enable Register: Checked
Display Name:
“AtcomUser” in this example
Figure 4-8. Account Configuration
2.
Once you have entered the required information, click on ‘Apply’
button located at
the end of the page. To check if the phone is registered, refresh the current page and see
the “Register Status” label
. If the phone is not register make sure you have entered the
right information (Figure 4.9).
Figure 4.9. VOIP
3. Configure the other IP (SIP) Phone with the correct parameters.
