IPPBX IP02 User Manual
~ 5 ~
ATCOM TECHNOLOGY CO., LIMITED
NOTE
: It’s recommended to re-set IP address of IPPBX via WAN at the first time, Since DHCP server on LAN
port is enabled by default, Other DHCP client enabled devices in the network may obtain IP from IPPBX rather
than real DHCP server. And then access IPPBX via LAN after configuring LAN settings.
1) Connect IPPBX to your PC directly or through switch.
Make sure IP address of your PC is in network 192.168.1.0/255.255.255.0, if not, you need to appoint an IP
address for your PC, for example, 192.168.1.3
2) Login IPPBX as administrator via WEB GUI
User:
admin
Password:
atcom
NOTE
:
Language option will be accomplished in future versions, currently, only English is supported. So it’s not
selectable now.
3) Go to
Network Settings
->
WAN
.
Re-set IP of WAN port.
4) Go to
Network Settings
->
LAN
.
Re-set IP of LAN port.
2.2 WAN Settings
There are three ways to set an IP address to WAN port: DHCP, Static IP, PPPoE.
DHCP
IPPBX will obtain an IP address automatically from DHCP server when rebooting
. It’s not recommended to
choose this option unless there is a reserved IP for IPPBX in DHCP server so that IPPBX can keep the same IP
all the time.
Summary of Contents for IPPBX IP02
Page 1: ...IPPBX IP02 User Manual For Firmware Version V3 0 2013 12 11...
Page 45: ...IPPBX IP02 User Manual 43 ATCOM TECHNOLOGY CO LIMITED 2 Set inbound route for FXO trunk...
Page 65: ...IPPBX IP02 User Manual 63 ATCOM TECHNOLOGY CO LIMITED...
Page 69: ...IPPBX IP02 User Manual 67 ATCOM TECHNOLOGY CO LIMITED Finish...