12. Always when using the tool, adopt a firm footing and/or position and grip the tool sufficiently only to overcome any
reaction forces that may result from the tool doing work.
DO NOT
over grip.
13. Use only correct spare parts for maintenance and repair.
DO NOT
improvise or make temporary repairs. Major
servicing and repairs should only be carried out by a qualified person.
14.
DO NOT
lock, tape, wire, etc the “ON/OFF” valve in “ON” position. The throttle/lever, etc must always be free to
return to the “OFF” position when released.
15. Always shut off the air supply to the tool and press the ‘ON/OFF” valve to exhaust the air from the feed hose before
fitting, removing or adjusting the working attachment fitted to the tool.
16. Before using the tool, make sure that a shut off device has been fitted to the air supply line and the position is
known and easily accessible so that the air supply to the tool can be shut off in an emergency.
17. Check hose and fittings regularly for wear.
18. Take care against entanglement of the moving parts of the tool with clothing, hair, ties, cleaning
rags, rings, jewelry,
watches, bracelets, etc. This could cause the body or parts of the body to be drawn towards and in contact with the
moving parts of the tool and could be very dangerous.
19. It is expected that users will adopt safe working practices and observe all local, regional and country legal
requirements when installing, using or maintaining the tool.
20. Take care that the exhaust air does not point towards any other person or material or substance that could be
contaminated by oil droplets. When first lubricating the tool or if the tool exhaust has a high oil content,
DO NOT
allow the exhaust air to come near very hot surfaces or flames.
21. Never lay the tool down until the working attachment has stopped moving.
22. When the tool is not in use, shut off the air supply and press trigger/lever to drain the supply line. If the tools is not
to be used for a period of time, first lubricate, disconnect from air supply and store in a dry average room
temperature environment.
23. If the tool is passed from one user to a new or inexperienced user, make sure these instructions are passed with
the tool.
24.
DO NOT
remove any manufacturer fitted safety devices where fitted, i.e. wheel guards, safety trigger, speed
governors, etc.
25. Whenever possible, secure work piece with clamps, a vise, etc. to make it rigid so it does not move during the work
operation. Keep good balance at all times.
DO NOT
stretch or overreach.
26. Try to match the tool to the work operation.
DO NOT
use a tool that is too light or heavy for the work operation. If in
doubt, seek advice.
