Assembly Instructions:
1.
align the screw hole with the screw, rubber ring, and the hole on
the support frame, then insert the wrench knob to tighten them up. (fig.1,2.)
Fig.1
Fig.2
2. Align the holes on the bottom of the U-shaped bracket with clamping support, then insert the
screw with washer, tighten up with washer and nut. (fig.3,4)
Fig.3
Fig.4
3. Insert the end
with screw holes
of the inner pole
into the clamping support. Insert the short
screw through the holes on the clamping support and inner pole with washers. Tighten up with the
washer and nut. (fig.5,6
Ϳ^ŚŽǁŶĐŽŵƉůĞƚĞŝŶĮŐ͘ϳ͘
Fig.5
Fig.6
Fig.7
On both sides of the fan head
VFUHZ KROH
VXSSRUW IUDPH
UXEEHU ULQJ
ZUHQFK NQRE
VFUHZ
