2
Save these instructions.
For your safety, read, understand, and follow the information provided with and on this jack.
The owner and operator of this equipment shall have an understanding of this jack and safe operating procedures
before attempting to use. The owner and operator shall be aware that use and repair of this product may require
special skills and knowledge. Instructions and safety information shall be conveyed in the operator's native language
before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack, remove from service
immediately.
Inspect before each use.
Do not use if broken, bent, cracked, or damaged parts (including labels)
are noted. Any jack that appears damaged in any way, operates abnormally or is missing parts, shall be removed
from service immediately. If the jack has been or suspected to have been subjected to a shock load (a load dropped
suddenly, unexpectedly upon it), immediately discontinue use until jack has been checked by an authorized factory
service center. It is recommended that an annual inspection be done by qualified personnel. Labels and Operator's
Manuals are available from manufacturer (see Replacement Parts, pages 5 thru 7).
PRODUCT DESCRIPTION
ATD Tools Long Chassis Hydraulic Service Jacks are designed to lift,
not
sustain, rated capacity loads. They are
designed to be used in conjunction with jack stands.
Intended use:
To lift one axle of a vehicle for the purpose of
service and/or repair of vehicle components. After lifting, loads must be immediately supported by appropriately
rated jack stands. Check with vehicle owner's manual for proper lift points.
DO NOT USE TO DOLLY OR MOVE VEHICLE. DO NOT USE FOR ANY PURPOSE OTHER THAN THOSE USES
OUTLINED ABOVE!
SPECIFICATIONS
Figure 1 - Typical Long Chassis Jack Nomenclature (ATD-7396 shown)
Handle Position Lock
Release Valve
(Handle Knob)
Saddle
Foot Pedal
Oil Filler Plug/Screw
(on Reservoir)
Handle
Front Wheel
Rear Caster
Handle Sleeve
Grease Fitting Nipple
Model
Capacity
Jack Size ( L x W x H)
Min. Height Max. Height
Ram Extend
Saddle Dia.
ATD-7396
10 Ton
54 3/4" x 20" x 12 3/4"
7"
27"
6 1/2"
7 3/8"
