2
CAUTION: READ CAREFULLY BEFORE UNPACKING PRODUCT.
Save these instructions:
For your safety, read, understand, and follow the information provided with and on this jack. The owner and operator of this
equipment shall have an understanding of this jack and safe operating procedures before attempting to use. The owner and
operator shall be aware that use and repair of this product may require special skills and knowledge. Instructions and safety
information shall be conveyed in the operator's native language before use of this jack is authorized. If any doubt exists as
to the safe and proper use of this jack, remove from service immediately. Inspect before each use. Do not use if broken,
bent, cracked or damaged parts are noted. Any jack that appears damaged in any way, or operates abnormally shall be
removed from service immediately. If the jack has been or suspected to have been subjected to a shock load (a load dropped
suddenly, unexpectedly upon it), immediately discontinue use until jack has been checked by a Factory Authorized
Service Center. It is recommended that an annual
are available from manufacturer.
PRODUCT DESCRIPTION:
ATD Tools Hydraulic Transmission Jacks are designed to be used as an aid in the removal and installation of automotive and
light truck transmissions, transfer cases and transaxles. They are intended for use under an overhead lift or in a garage pit.
These jacks comply with applicable ASME-PALD Standards. The air actuated function is an added feature of model ATD-7434.
For ATD-7434, ensure the air source can dedicate 7.8 CFM @ 90-175 psi. To ensure dependable, trouble free operation an
inline air dryer and oiler is recommended.
SPECIFICATIONS:
Model
Capacity
Min.
Height
Max.
Height
Min. Saddle Area
Max. Saddle Area
Base Size
ATD-7433
2000 lbs.
48-5/8”
77-3/8”
15-1/2" x 12-5/8"
24-1/2" x 18-7/8”
42-1/8" x 39-1/2"
ATD-7434
2000 lbs.
48-5/8”
77-3/8”
15- 1/2" x 12- 5/8"
24-1/2" x 18-7/8”
42-1/8" x 39-1/2"
Weight
316.4 lbs.
348 lbs.
Note: Vent Screw and Oil Filler Screw are located on the upper portion of the reservoir.
Figure 2 - Model ATD-7434 nomenclature
Air Pump
Air Pump Pedal
Air Supply Inlet
(not shown)
Release Valve
Lift Pedal
Saddle
Assembly
Tilt Adjustment
Knobs
Position Handle
Oil Filler Screw
(not shown)
Swivel Caster
Base Halves
Reservoir
Chain
Support Bar
Bracket
Figure 1 - Model ATD-7433 nomenclature
Saddle
Assembly
Lift pedal
Position Handle
Oil Filler Screw
(not shown)
Base Halves
Swivel Caster
Reservoir
Tilt Adjustment
Release Valve
Knobs
Chain
Support Bar
Bracket
