BEFORE USE
1. Inspect jack before each use. Do not use if bent,
broken or cracked components are noted. Ensure
that casters move freely. Check for and tighten any
loose assemblies.
2. Verify that the product and the application are
compatible.
3. Remove oil filler plug/screw prior to initial use to
confirm oil level is at or just above the inner cylinder
as seen from the reservoir, fill as needed and
reinstall oil filler plug/screw.
2
Save these instructions
For your safety, read, understand, and follow the information provided with and on this jack. The owner and operator of
this equipment shall have an understanding of this jack and safe operating procedures before attempting to use. The
owner and operator shall be aware that use and repair of this product may require special skills and knowledge.
Instructions and safety information shall be conveyed in the operator's native language before use of this jack is
authorized. Make certain that the operator thoroughly understands the inherent dangers associated with the use and
misuse of the product. If any doubt exists as to the safe and proper use of this jack, remove from service immediately.
Inspect before each use.
Do not use if broken, bent, cracked or damaged parts are noted. Any jack that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If the jack has been or
suspected to have been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately
discontinue use until jack has been checked by a factory authorized service center. It is recommended that an
annual inspection be done by qualified personnel. Labels and Operator's Manuals are available from manufacturer.
PRODUCT DESCRIPTION
ATDTools Hydraulic Transmission Jacks are designed to be used as an aid in the removal and installation of automotive
and light truck transmissions, transfer cases and transaxles. They are intended for use under an overhead lift or in a
garage pit. These jacks comply with applicable ASME-PALD Standards.
SAFETY INSTRUCTIONS
SPECIFICATIONS
Study, understand, and follow all printed materials
provided with/on this product before use.
Do not exceed rated capacity.
Use only on hard, level surfaces capable of supporting
rated capacity loads.
Use of this jack is limited to the removal, installation
and transportation of transmissions, transfer cases
and transaxles. Do not use a transmission jack to tilt
or support a vehicle.
Ensure the center gravity of load is centered on the saddle.
For your safety, do not exceed 10
Û
tilt angle of the
saddle assembly in all directions.
Adequately support the vehicle before starting repairs.
Use only chains and slings provided.
If loaded jack must be moved, make sure that the load
is secured, stable and in lowest position.
This is a lifting and lowering device only.
Transfer load immediately to appropriate support
device for service or repair.
Shock loads may cause the sudden loss of load and/ or
cause the jack to tip or flip over violently, bend or break.
No alterations shall be made on this product
Failure to heed these markings may result in personal
injury and/or property damage.
!
WARNING
CAUTION!
Read carefully before unpacking product
Model
ATD-7435
ATD-7436
ATD-7437
1000 lbs.
2000 lbs.
3000 lbs.
8-1/2”
7-7/8”
7-7/8”
24-3/4”
33-1/2”
37-1/4”
12-5/8” x 7-7/8”
14-1/4” x 8”
15-1/2” x 13-1/4”
17” x 19-3/8”
17” x 15-3/4”
24-7/8” x 19”
31” x 15”
39-3/8” x 19-1/8”
46-3/4” x 25-5/8”
22-1/2”
22-1/2”
29-1/2”
106 lbs.
200 lbs.
346 lbs.
Capacity
Minimum
Height
Maximum
Height
Saddle Base
Expanded Saddle
Area
Base Size
Handle
Length
Weight
