Threaded sha
Ō
Installa
Ɵ
on:
Before installa
Ɵ
on, use ethyl alcohol and compressed air to clean up the center hole of the sha
Ō
and connector.
Use hex wrench and screw to
ĂƩĂĐŚ
the threaded sha
Ō
to the balance sha
Ō
(FIG. 005)
From the workarea, the user must be able to see the machine and the surrounding area.
THE INSTALLATION AREA MUST BE KEPT CLEAR OF ANY DANGEROUS OBJECTS.
UNAUTHORIZED PERSONNEL MUST NOT STAND IN THE WORK AND INSTALLATION
AREAS.
THE MACHINE MUST BE PLACED ON A HORIZONTAL, PREFERABLY A CONCRETE FLOOR.
THE SURFACE MUST WITHSTAND THE LOADS TRANSMITTED DURING OPERATION.
THE MACHINE MAY BE ONLY USED IN PLACES THAT DO NOT POSE ANY EXPLOSION OR
FIRE HAZARDS.
8. USE SUSPENSION
Should the machine not be used for long periods, disconnect the power supply and protect all parts that could be damaged
by dust. Grease all parts that could be damaged in case of oxida
Ɵ
on.
In this speci
Į
c case, protect the sha
Ō
and
Ň
ange.
9. ENVIRONMENTAL INFORMATION
THE DISPOSAL PROCEDURE DESCRIBED BELOW ONLY APPLIES TO
MACHINES WITH THE SYMBOL OF THE CROSSED-OUT WHEELIE BIN
ON THEIR DATA PLATES.
The crossed-out trash bin symbol, placed on the product and on this page, reminds the user that the product must be
disposed of properly at the end of its life. This product may contain substances that can be hazardous to the environment
and to human health if it is not disposed of properly. We are therefore providing you with the informa
Ɵ
on below in order
to prevent these substances from being released into the environment, and to improve the use of natural resources.
Electrical and electronic equipment must never be disposed of in the usual municipal waste but must be separately
collected for proper treatment. Thus, the hazardous consequences that non-speci
Į
c treatments of the substances
contained in these products, or improper use of parts of them, may have on the environment or on human health are
prevented. Furthermore, this helps to recover, recycle and reuse many of the materials contained in these products. For
this purpose, electrical and electronic manufacturers and distributors set up proper collec
Ɵ
on and treatment systems for
AVOID BREAKABLE SURFACES SUCH AS CERAMIC TILE AND ROUGH SURFACES SUCH AS GRAVEL.
THE MACHINE MUST BE ELECTRICALLY GROUNDED.
these products. At the end of the product service life, contact your local recycler for informa
Ɵ
on about disposal procedures.
7
