AD-WM-9080 Page 1 of 4
Installation Guide
AD-WM-9080
Full Motion Wall Mount 9080
COMPONENT CHECKLIST
W
Full Motion Wall Mount
Assembly
X
Display Bracket
(x2)
Y
Security Clip
(x4)
Z
Drilling Template
C
M6x16
Screw
(x4)
G
M8x45
Screw
(x4)
A
M4x16
Screw
(x4)
E
Washer
(x4)
B
M5x16
Screw
(x4)
F
D
M8x25
Screw
(x4)
H
Spanner
M5x8
Security Screw
(x4)
IMPORTANT INFORMATION
! Please ensure this product is installed as per these installation instructions.
! The manufacturer accepts no responsibility for incorrect installation.
! Failure to mount this product correctly may cause serious injury/death during or following installation.
! This product is not suitable for outdoor use.
! Do not use this product for mobile applications.
! This product supports a maximum load of 90.7kg (200lb).
! Wall Plate only achieves maximum weight rating when appropriately fastened to a wall of adequate structural capacity.
! Professional installer to ensure adequate structural capacity of wall (including appropriate safety factor) to support total
weight of all equipment being mounted.
! Drilling into electrical wires can cause death - use appropriate equipment and caution when drilling holes in walls to avoid
electrical cables, water pipes and gas pipes. Do not drill into structures unless you have established it’s safe to do so.
! Suits displays with mounting hole patterns from 100mm to 800mm wide by 100mm to 600mm high.
REQUIRED TOOLS
• Stud finder
• Spirit level
• Power drill
• Suitable drill bits
• Driver bit for selected
wall fasteners
• Phillips head screwdriver
• Socket wrench set
NOTE:
! Wall Plate Mounting Fasteners are
NOT
supplied with Wall Mounts.
Professional installer to ensure correct Mounting Fastener type, location &
quantity to suit structure where Wall Mount is installed.
!
ALWAYS
use a washer between the chosen fastener and the wall plate.
! Mounting fasteners to be used as per manufacturers instructions, including
minimum engagement to achieve necessary performance.
0 - 90.7kg
(0 - 200lb)
WEIGHT CAPACITY
