19
Operating and Safety Instructions
10. MAINTENANCE
10.1. ROUTINE CONTROLS and MAINTENANCE
10.1.1 BEGINNING OF THE WORK
10.1.1.
Ensure that the table and all kind of parts are clean and dry. Degrease and dry the
table. Especially ensure that the holding grips are clean and dry.
10.1.2.
Remove all burr, chip and foreign materials from all surfaces of the machine. Use
protective eye glasses.
10.1.3.
Check the saw blade before each use. Turn the saw blade carefully (after
removing the blade guard) to see the teeth of the saw blade. Replace the saw blade if it
is damaged.
10.1.4.
Check the pressure of the air pressure system. If necessary, adjust the air pressure
between 7-8 Bar.
10.1.5.
Check the air pressure filters and the oil level of the conditioner. Fill up if the oil level
is low.
Unplug and disconnect the air pressure connections first, before carrying out these works.
10.2. MAINTENANCE AT THE END OF THE WORKING DAY
10.2.1.
Disconnect electric and pneumatic connections. (Main Switch must be on “0”
position)
10.2.2.
Remove all burr, chip and foreign materials from the machine surfaces. If it is
necessary to clean the inside of the blade guard, remove the front cover, use gloves to
protect your hands from the sharp edges of the blade.
10.2.3.
If water or water based liquids were used during cutting, dry the machine with a
dry cloth after the operation is finished.
10.2.4.
Apply a thin layer of machine oil to protect the table against corrosion. If the
machine will not be used for a long time, lubricate with a protective oil.
10.2.5.
Don’t use materials for cleaning the machine, which could damage its paint.
10.2.6.
Lubricate both surfaces of the saw blade with machine oil in order to protect it
against corrosion.