6.6.4.
Routine maintenance and scheduled maintenance should be carried out by qualified personnel after
unplugging the
machine and disconnecting the air supply first.
6.6.5.
Ensure that the machine has been cleaned, tested and maintenance before starting to operate.
6.6.6.
Check the safety devices, power cable and moving parts regularly. Don’t operate the machine before
having replaced
defective safety devices or faulty parts
6.6.7.Never replace the circular saw without disconnecting the air and the electrical and pneumatic power
connection.
6.6.8.
Keep foreign materials away from the working area of the machine, keep away from the machine’s moving
parts.
The saw blade continues its rotation for a while after switching off the motor.
Don’t use the machine for purposes other than it has been designed for (cutting of iron and
other ferrous materials).
The safety data have been defined above. In order to prevent physical damage or
damage to the equipment, please read the safety information carefully and keep the
manual always in an easy accessible place.
If the top cover is open, the engine will not start in terms of worker safety
.
7.OPERATION
CRATER Undercutting cutters cut products made from Aluminum, Wood and hard plastic materials which are
not ferrous alloy. The operator adjusts the cutting progress of the saw according to the type and size of the
material. (Manual) The inner and outer sharp edges of the circular saw allow you to obtain a smooth surface at
high quality
.
7.1. Angled Cutting On The Plate
7.1.1.
Do not try to cut the parts / materials that you want to cut before tighten the clamps on the machine
.
7.1.2.
The vices on the machine are in vertical or horizontal position. The pneumatic clamps can be easily
adjusted to the material
.
7.1.3.
The clamp piston moves in the pneumatic clamps
.
During the cutting process, the clamping lugs of the clamps must be outside the work area of the
circular sawing
.
14
