12
If the top guard is open, the motor will not start in terms of worker safety
.
However, you can tighten the
clamps with the top guard open so that you can place your profile and adjust and tighten it.
7.
OPERATION
In the automatic cutting section, it provides automatic cutting in desired length, equal lengths and desired number from
the workpiece. Select how many seconds intervals the coolant will be activated from the settings page, it is between 0.5
seconds and 2 seconds depending on the material thickness. Then, by opening the Recipe page, write the desired length value
of the workpiece to be sliced in the “MEASURE TO CUT” section. Write the number of profiles to be processed (how many
profiles will be connected at the same time) in the "NUMBER OF PROFILES". For precise and clean cut, write the saw cutting
speed to “CUTTING SPEED” (meters / min). Write the total profile height in the "PROFILE HEIGHT" to adjust the saw output
height. How many cuts are written in the "CUTTING NUMBER" section. Bring the end of the profile to the middle of the saw
channel and fix the profile with clamps by pressing the green button. If the clamps do not tighten the profile, you can open it
by pressing the green button once more and adjust your vices according to the profile, do not forget to make the adjustment
both in the driver and machine part. If you are sure that you press the green button and tighten the profile, after you press the
"START" button on the screen, it will automatically start cutting. The cutting process will start with tip cleaning. In the
meantime, check the height and speed of sawing. In the opposite case, your hand will be on the emergency stop button. The
cutting process will continue until the specified number is completed or the profile ends until the cutting process starts. When
the work piece on the machine is finished, the machine will go to the stop position and wait for you to press the "START"
button. If it is desired to stop cutting or exit the page while slicing, press “STOP” button and wait for the machine to stop. When
the machine stops, the page can be exited and switched to another page, or the machine can continue slicing from where it
left off by pressing the "START" button.
7.1.
Presentation of the Panel and Program Entry
CRATER AP500 Automatic cutting machines use of electronic positioning device;
Emergency Stop
Button
Clamp Button
Electronic LCD Control
Panel