17
9.
SAFE INSTALLATION OF THE BELT
Follow the instructions below to safely replace the CRATER AP500 machine belt.
9.1.1.
Remove the saw by performing saw changing operations.
9.1.2.
Remove the saw casing sheet metal cover.
9.1.3.
Remove the M6 screw by turning with a 5 mm allen key.
9.1.4.
Remove the belt cover.
9.1.5.
Loosen the M8 screws by turning them clockwise with a 6 mm Allen key.
9.1.6.
Loosen the M10 key-head bolt with the 10 mm keys.
9.1.7.
You can change the belt by loosening the motor block.
9.1.8.
Once you have changed the belt, finish the process by following the procedures.
10.
MAINTENANCE
1.
Routine Controls, Maintenance And Work Starting
1.1.
Make sure the table and all parts are clean and dry. Clean the table from the oil and dry it. Be especially sure of the
cleanliness and dryness of the handle
.
1.2.
Clean all surfaces of the machine from the sawdust, chips and foreign materials. Use glasses and glove to protect
yourself from harmful substances
.
1.3.
Check the saw blade against wear, bending, cracking and breakage before each use. Turn carefully to see each tooth
of the saw (after removing the saw protective housing). If the saw is damaged, change the saw
.
1.4.
Check the air pressure system pressure. If necessary, set the air pressure around 6-8 bar.
1.5.
Check the air pressure filters and the oil level in the conditioner. If you do not have enough oil, complete it.
Loosen with 10 mm key
