Chapter 4. Local Console Operation
27
(Continued from previous page.)
(Continues on next page.)
Setting
Function
SCAN
DURATION
Determines how long the focus dwells on each port as it cycles
through the selected ports in Auto Scan Mode (see
page 32). Key in a value from 0–255 seconds, then press
[Enter]
.
Default is 10 seconds; a setting of 0 disables the Scan function.
SCAN/SKIP
MODE
Selects which computers will be accessed under Skip Mode (see
, page 31), and Auto Scan Mode (see
Choices are:
ALL
- All the Ports which have been set Accessible (see
POWERED ON
- Only those Ports which have been set
Accessible and are Powered On;
QUICK VIEW
- Only those Ports which have been set Accessible
and have been selected as Quick View Ports (see
QUICK VIEW + POWERED ON
- Only those Ports which have
been set Accessible and have been selected as Quick View Ports
and are Powered On.
The default is
ALL
.
SCREEN
BLANKER
If there is no input from the console for the amount of time set with
this function, the screen is blanked. Key in a value from
0–30 minutes, then press
[Enter]
. A setting of 0 disables this
function. The default is 0 (disabled).
HOTKEY
COMMAND
MODE
Enables / Disables the Hotkey Command function in case a
conflict with programs running on the computers occurs. The
default is ON.
HOTKEY
This setting selects the Hotkey invocation keys (see
, page 34). Choices are:
[Num Lock] + [–]
or
[Ctrl] + [F12]
The default is [Num Lock] + [–].
SET LOGOUT
TIMEOUT
If there is no input from the console for the amount of time set with
this function, the Operator is automatically logged out. A login is
necessary before the console can be used again.
This enables other Operators to gain access to the computers
when the original Operator is no longer accessing them, but has
forgotten to log out. To set the timeout value, key in a number from
0–180 minutes, then press [Enter]. If the number is 0 (zero), this
function is disabled. Default is 0 (disabled).
kh15816i.book Page 27 Wednesday, December 26, 2007 11:12 AM
