Chapter 4. Local Console Operation
37
Invoking Auto Scan
To start Auto Scanning, key in the following Hotkey combination:
1. Invoke Hotkey Mode (see page 34).
2. Press
[A]
.
After you press
A
, you automatically exit Hotkey Mode, and enter Auto
Scan Mode, and Auto Scanning begins.
While you are in Auto Scan Mode, you can pause the scanning in order
to keep the focus on a particular computer by pressing
P
or clicking
with the mouse. During the time that Auto Scanning is paused, the
Command Line displays:
Auto Scan: Paused.
Pausing
when you want to keep the focus on a particular computer is
more convenient than Exiting Auto Scan Mode because when you
Resume scanning, you start from where you left off. If, on the other
hand, you Exited and restarted, Scanning would start over from the
very first computer on the installation.
To resume Auto Scanning, press any key or click with the mouse.
Scanning continues from where it left off.
While Auto Scan Mode is in effect, ordinary keyboard and mouse
functions are suspended - only Auto Scan Mode compliant keystrokes
can be input. You must exit Auto Scan Mode in order to regain normal
control of the console.
3. To exit Auto Scan Mode press
[Esc]
or
[Spacebar]
. Auto Scanning stops
when you exit Auto Scan Mode.
kh15816i.book Page 37 Wednesday, December 26, 2007 11:12 AM
