Chapter 1. Introduction
11
Note:
Holes for ATEN Lok-U-Plug cable holders are located around the
sockets. See
, page 21, for further information.
No.
Item
Description
1
Power Socket
The power cord that connects the unit to an AC
power source plugs into this IEC 320 C20 socket.
2
Circuit Breaker
Pushbutton
As a safety measure, if there is an overcurrent
situation regarding the device’s power, the circuit
breakers will trip. Press the button to recover
normal operation.
3
Power Sockets*
2 x IEC 320 C13
4
14 x IEC 320 C19
5
Sensor Ports
External sensors plug into these two RJ-11 ports.
6
LAN Port and LEDs
The cable that connects the eco PDU to the LAN
plugs in here. The Link and LAN LEDs are built
into the LAN port:
Link
: Lights GREEN to indicate that a connection
via the eco PDU's RJ-45 Ethernet port has been
established. Flashes to indicate data is being
transmitted.
LAN
: Lights ORANGE to indicate 10 Mbps data
transmission speed. The LED lights GREEN to
indicate 100 Mbps data transmission speed.
7
Readout Section, LEDs
and Reset Switch
Details of this section are provided on page 16.
8
Outlet Status LEDs
[PE6216 models only] These LEDs indicate outlet
status.
Lights ORANGE for powered on.
Off for powered off.
