UPS User Manual
50
When installing the equipment, it should ensure that the sum of the
leakage current of the UPS and the connected devices does not
exceed 3.5mA.
Temperature Rating - Units are considered acceptable for use in a
maximum ambient of 40°C (104°F).
For Pluggable Equipment - The socket-outlet shall be installed near
the equipment and shall be easily accessible.
For normal operation of the UPS (at full load UPS), it is required to
keep the unit below a maximum altitude of 3000m.
Operation
Do not disconnect the mains cable on the UPS system or the
building wiring outlet (shockproof socket outlet) during operations
since this would cancel the protective earthing of the UPS system
and of all connected loads.
The UPS system features its own, internal current source
(batteries). The UPS output sockets or output terminals block may
be electrically live even if the UPS system is not connected to the
building wiring outlet.
In order to fully disconnect the UPS system, first press the OFF/
Enter button to disconnect the mains.
Prevent no fluids or other foreign objects from entering the inside of
the UPS system.
To reduce the risk of fire, connect only to a circuit provided with X
(in ampere, refer to the table below) maximum branch circuit
overcurrent protection in accordance with the National Electrical
Code, ANSI/NFPA 70 and the Canadian Electrical Code, Part I,
C22.1.
Model
X
OL1000LV, OL1000SLV,
OL1500LV,
OL2000LV, OL2000SLV
20A
OL3000LV
40A
Summary of Contents for NRGence HV Series
