eco PDU PG Series User Manual
71
If you didn't enable
Check Main Firmware Version
, the upgrade file is
installed without comparing.
Once the upgrade completes successfully, the switch restarts
automatically.
4. Log in again, and check the firmware version to be sure it is the new one.
Firmware Upgrade Recovery
Should the eco PDU’s firmware upgrade procedure fail, and the device
becomes unusable, the following firmware upgrade recovery procedure will
resolve the problem:
1. Power off the device.
2. Press and hold the Reset Switch in (see page 5).
3. While holding the Reset Switch in, power the switch back on.
This causes the switch to use the original factory installed main firmware
version. Once the switch is operational, you can try upgrading the firmware
again.
Summary of Contents for PG98230 Series
