Chapter 3. Front Panel Configuration
35
IR Remote Control Operation
The IR remote control (
, page 9) included with the
VM5404H / VM5808H can be used to:
change the Input source of any Output display
power on/off individual Output displays; or
power on/off all Output displays simultaneously
Before using the remote control, a user must first plug the IR External Receiver
into the rear panel of the VM5404H / VM5808H and place the receiver where
the IR signal can be reached (see
Change the Input source of an Output display
To change the Input source of an Output display, using the remote control, do
the following:
1. Press the
Output
port number (
1–8
) or (
1-4
) you want to change.
2. Within 2 seconds press the
Input
port number (
1–8
) or (
1-4
) you want the
Output port to display.*
3. Repeat steps 1-2 to change additional ports.
*For the change to occur the Input number must be pressed within 2
seconds of pressing the Output number.
Power on/off individual Output displays
To power on/off individual Output displays, using the remote control, do the
following:
1. Press the
Output
port number (
1–8
) or (
1-4
) you want to power on/off.
2. Within 2 seconds press the
ON
or
OFF
pushbutton.*
3. Repeat steps 1-2 to change the power status back on/off.
*If the
ON
or
OFF
pushbutton is pressed
after
2 seconds of pressing the
Output port number, all the displays are powered on or off instead of just
the intended Output port.
