31
32
6
GUI instruction
6.1 LCD display screen introduction
User can view the information of the inverter operation on the LCD touch screen, as
well as setting the operating parameters. In order to facilitate the operation, a menu
is provided below.
Table 6-1 ATESS PCS100 LCD Menu
After powering on the LCD, it will initialize itself first, and then enter the boot which
displays the progress bar of starting up. The main interface will display after finishing
the startup (about 20S, if the progress bar has not been finished after 60S, there is
communication problem between LCD and control board). Then you can begin to
read the information and set the parameters.
Inverter communication state, station number and system time is displayed at the top
of each page of the LCD.
Each page has five commonly used function keys: "run data" “historical
information” "system settings" “Home” at the below of the page. The five
commonly used keys corresponding sub-menu are under the button, and it will be
marked green after selected.
6.2.1 Home page
Clicking “Home” button in any interface will enter into the Home page.
The operating status of the inverter output power, safety standard, model, input and
output voltage, current information can be viewed in the page. Pressing the
following key can switch to other pages.
6.2 LCD operation
6.2.2 ON/OFF interface
Clicking “ON/OFF” button in any interface will enter into this interface.
There are “ON” and“OFF” button which is used to turn on and turn off the inverter.
After selecting, a sub-window will pop up for confirmation: Yes/No.
