www.atestgaz.pl
Do never leave spare lengths of cables inside the device. Bare wires or wires surplus may
lead to a hazard of electric shock or equipment damage.
Do never leave redundant cable cores not terminated inside the device.
Incorrect routing of cables may result in impairment of the equipment immunity to
electromagnetic interferences.
8.2.1
List of tools necessary for installation of the signaller
Denomination
Tool
N1
Allen socket wrench, 2.5 mm, with a ball tip
N2
Open-end flat spanner, 22 mm
Table 7: List of tools necessary for installation of the signaller
8.2.2
Installation sequence
The device must be mounted on a flat and vertical wall with the cable inlet looking downwards as shown in
Figure 2 and then fixed by means of two bolts /screws ①. Any other position of installation is not allowed.
s. 14|23
User Manual: POD-037-ENG R06