® Copyright by ATH-Heinl GmbH & Co. KG, 2014, All rights reserved /Misprint and technical changes reserved / Issue:
08/2013
5
INSTALLATION
The machine should be installed only by authorized personal according to the manual.
Transport and storage
Always use suitable means for transporting and
positioning the machine and keep attention to the gravity
center of the machine.
The machine should only be transported with the original
packing.
Type
A31
A34
Lenght
1.550 mm
1.220 mm
Width
820 mm
1050 mm
Height
310 mm
340 mm
Weight
90
110 kg
Storage
temperature
0°C
～
+50 °C
Unpacking of machine
Remove the upper cover of the carton and make sure that there were no damages during the transport.
Remove the safety bolts to get the machine from the pallet.
For taking the machine from the pallet use a suitable means (eventually with sling).
The packing material of the machine should be stored carefully.
Keep the packing material away from children as it could be dangerous for them.
Standort
The machine should be kept away from flammable and explosive materials as well as from solar radiation and intensive
light. The machine should also be installed in a well-ventilated place.
The tire changer must be placed on a concrete floor or similar solid flooring.
When selecting the place of installation, besides the soil condition also the guidelines and instructions of the accident
prevention regulations and workplace regulations must be observed.
It is not allowed to install the machine outside, but only inside, as the machine has no corresponding safety provisions (IP-
protection, zinc coated and so on)
Temperature
0-50 °C
Air humidity
10-90% (ohne Kondensation)
Sea level
≤2000m
Fixing
Here, the general and local regulations must be observed. Therefore this step must be performed only
by an expert.
Pay attention to the correct current supply. (see technical data).
1. Preparation:
a. Disconnect the tire changer from any electrical or pneumatical connection
b. Check the correct fixing of tire changer
