® Urheberrecht ATH-Heinl GmbH & CO.KG, Alle Rechte vorbehalten / Druckfehler und technische Änderungen vorbehalten / Stand: 2021-07
Produkthersteller ATH-Heinl GmbH & CO.KG
- 12 -
General
The transmission oil within an automatic gearbox should be replaced at regular intervals, as otherwise the gearbox
can no longer be guaranteed to function properly. In the current oil change process, only the oil, which was in the oil
pan of the automatic transmission was exchanged. These were usually 3 litres to a maximum of 5 litres and this does
not correspond to the complete change of the entire oil fill quantity of the transmission. Due to the design or by the
elimination of the drain screw from the converter including the oil cooler, a considerable amount of old ATF oil
remained in the transmission system, resulting in a mixing of the new ATF oil with the contaminated and spent old
ATF oil, as well as the deposits and abrasion particles in the system. The ATF602 can rinse the transmission, torque
converter and radiator or carry out a complete oil change within a short time. The oil exchange rate is almost 100%.
WITH THE ATF602, THE AUTOMATIC GEARBOX CAN NOT BE VERIFIED, THE VEHICLE
MANUFACTURERS AND INSTRUCTIONS SHOULD BE CAREFULLY.
Function list
Main functions
Flushing
Flushing of automatic transmission.
Flushing can only done when automatic transmission is running.
(engine have to turn on)
Changing
Exchange the used oil in the transmission with new oil.
Correction of oil
level
Filling or drain oil of the automatic transmission
Drain
Drain the used or new oil tank
Settings
Calibration
Calibration of scales for used and new oil tank
Language
Choice of language
Set-up weights
Set-up the weight of empty new- and old oil tank
Unit of
measurement
Selection of metric or British measuring unit
Diagnosis
Direct control of solenoid valves and oil pump to test the system.
Preparation
1.
Raise the vehicle with the car lift until the drive wheels are completely in the air. Hereby the drive wheels
don´t have to touch anything. (Pic. 2)
2.
Oil level of the transmission have to checking by OEM requirements
TO AVOID DAMAGES AND ACCIDENTS:
VEHICLE MANUFACTURER'S INFORMATION MUST BE OBSERVED; Eg: THE VEHICLE MUST ONLY
BE DEDUCTED TO THE AUTHORIZED RECORDING POINTS.
HEBEBÜHNENHERSTELLERANGEBEN UNBEDINGT ZU BEACHTEN; z.B.: DIE BEDIENUNG DER
HEBEBÜHNE DARF NUR DURCH EINE FACHKUNDIGE PERSON DURCHGEFÜHRT WERDEN
