® Copyright ATH-Heinl GmbH & Co. KG, 2017, All rights reserved. / Misprint and technical changes reserved / Issue: 07/2018
- 12 -
Mounting
This manual is
not
to be mounting instructions but only as a help for skilled technicians. For the
following works, suitable clothes must be worn and individual safety devices must be made.
An incorrect mounting and setting excludes warranty and liability.
1.
Mounting of the wheel balancer
a.
Lift the wheel balancer from the pallet, use hereby solely the intended support points. In no
case lift the machine at other points as e.g. the shaft, the display or the accessory plate.
b.
The machine must stand firmly on the floor at the intended support points, if necessary
there must be used washers.
2.
Fixing with security anchors:
a.
Bore holes, pay attention in doing so
to the necessary boring depth A and
the boring diameter of the anchor
manufacturer
b.
Clean the inner of the holes
c.
Put the anchor bolts into the holes
until you reach the bottom of the
hole.
d.
Tighten the nut with the necessary
torque specified by the
manufacturer. Clamping thickness B
depends on flooring.
The wheel balancer must be fixed firmly on the floor for achieving an exact balancing result.
Summary of Contents for ATH W142
Page 1: ...USER S MANUAL ATH W142 ...
