® Copyright ATH-Heinl GmbH & Co. KG, 2017, All rights reserved. / Misprint and technical changes reserved / Issue: 07/2018
- 15 -
Loosen the screw on the side oft he wheel lift.
Push the drive-on ramp from front on the screw.
Fix the ramp by using the screw.
7.
Electrical connection
Here, the general and local regulations must be observed. Therefore, this step must be performed
only by an expert. Pay attention to the correct current supply. (see technical data).
The main connection cable of the machine is to be fitted with a plug that meets the appropriate
standards. If the machine is connected directly (without plug), it is recommended to secure the circuit
breaker for the balancing machine with a padlock, so that only the appropriate personnel have access.
Connect the machine with an own connection and an own suitable circuit breaker.
8.
Pneumatic connection
The air pressure should be corresponded to the
technical data.
The maximum or minimum pressure ensures
perfect function without any damage.
It´s recommended to use a shut-off valve (D
–
NOT included).
Connect the compressed air supply to the
maintenance unit (4).
For correct setting all instructions in the article
„maintenance and service instruction“
must now be
observed.
D
4
Summary of Contents for ATH W142
Page 1: ...USER S MANUAL ATH W142 ...
