30
2.6
Checks on the machine before each use
•
Visually check under and around the machine to make sure that there are no
oil or fuel leaks. If leaks are discovered, follow the MAINTENANCE
instructions.
•
Make sure that there is no hydraulic oil leaking from the hoses and from the
other components (cylinders, distributors, fittings, etc.).
•
Check that there are no cut or worn electrical cables and that the
connectors are correctly secured.
•
Check the fuel level before starting so as to prevent interruptions while
working.
•
Check the engine oil level.
•
Check the hydraulic oil level.
•
Do not run the engine in closed areas like garages or similar. The engine
exhaust gas contains carbon monoxide, a poisonous gas that can quickly
saturate a closed space and cause difficulties or even death.
•
Make sure that none of the screws, bolts or ferrules are loose or missing.
•
Make sure that all the "Seeger" safety rings are present and correctly in place
with their washers.
•
Make sure that all the pins are in place and correctly secured.
•
Check that the steel structure is not deformed.
•
Make sure there are no cracks in the welds, damage or abnormal wear
•
Make sure the tracks are not cut or abnormally worn
•
Always check to make sure that the track tension is correct
•
Check, and if necessary grease, the scissor runners, both those in contact
with the platform and those in contact with the lower frame.
•
Check that the manual, the plates and the stickers are on the machine.
•
Make sure that the 12V internal combustion engine ignition battery is fully
charged; a simple way to check is turning on the internal combustion engine,
which must turn on easily.
•
Make sure that the gate leading to the platform closes and locks itself
automatically once released.
2.7
General safety indications on the use of the platform
The instructions given below must be followed.
•
It is forbidden to use ladders or other structures in the basket to increase the
height of the machine.
•
It is forbidden to place structures inside the basket to increase the surface
area exposed to the wind.
Summary of Contents for 1090 EVO
